基于三维荧光光谱法和PARAFAC对多环芳烃定性定量分析

三维荧光光谱法在研究多环芳烃(PAHs)类物质的荧光信息时起到了重要作用。多环芳烃类物质具有致癌性,难降解性,多由尾气排放,垃圾焚烧产生,危害着人类健康及环境,因此人们不断探索对多环芳烃检测的方法。实验选取多环芳烃中的苊和萘作为检测物质,利用FLS920荧光光谱仪,为避免荧光光谱仪本身产生的瑞利散射影响,设置起始的发射波长滞后激发波长40 nm,设置扫描的激发波长(λex)范围为:200~370 nm,发射波长(λem)范围为:240~390 nm,对多环芳烃进行荧光扫描获取荧光数据,采用三维荧光光谱技术结合平行因子算法对混合溶液中的苊和萘进行定性定量分析。实验选用的苊和萘均购于阿拉丁试剂官网,配制浓度为10 mg·L-1的一级储备液,再将一级储备液稀释,得到苊和萘浓度为0.5,1,1.5,2,2.5,3,3.5,4和4.5 mg·L-1的二级储备液,并将苊和萘进行混合。在进行光谱分析前需要对苊和萘的光谱进行预处理,采用空白扣除法扣除拉曼散射的影响,并采用集合经验模态分解(EEMD)消除干扰噪声。实验测得苊存在两个波峰,位于λex=298 nm,λem=324/338 nm处,萘存在一个波峰,位于λex=280 nm,λem=322 nm处。选用的PARAFAC算法对组分数的的选择很敏感,因此采用核一致诊断法预估组分数,估计值2和3的核一致值都在60%以上,分别对混合样品进行了2因子和3因子的PARAFAC分解,将分解后得到的激发发射光谱数据和各组分浓度数据进行归一化处理,并绘制光谱图,与归一化处理后的真实的激发发射光谱图和各组分浓度图进行对比。同时将PARAFAC得到的混合样本的预测浓度,通过计算回收率(R)和均方根误差(RMSEP)来判定定量分析的准确度。选择2因子时,各混合样品中苊和萘拟合度为95.7%和96.7%,平均回收率分别为101.8%和98.9%,均方根误差分别为0.0187和0.0316;选择3因子时,各混合样品中苊和萘拟合度为95.3%和95.8%,平均回收率分别为97%和102.5%,均方根误差分别为0.033和0.116,由三项指标可得选用2因子进行定性定量分析的效果明显好于选用3因子。分析实验结果表明,基于三维荧光光谱法和PARAFAC算法对混合样品进行定性定量分析,能够有效的判定混合样品的类别,同时能够成功的预测出混合样品的浓度。     

离子浓度及表面结构对岩石孔隙内水流动特性的影响

酸性环境引发的岩石孔隙表面溶解增加了孔隙内水溶液的盐离子浓度,破坏了孔隙的表面结构.本文采用分子动力学模拟的方法研究了纳米级岩石孔隙内水溶液的流动特性,分析了盐离子浓度和孔隙表面结构对水流速度分布的影响及原因.研究结果表明:纳米级岩石孔隙内的水溶液流动符合泊肃叶流动特性,流速呈"抛物线"分布;随盐离子浓度增加,水溶液内部氢键网络变得更为致密,水黏度随其呈线性增长;水溶液中离子浓度越大,孔隙表面对水流动的阻力越大,最大流速越小,速度分布的"抛物线"曲率半径越大;岩石孔隙表面结构的破坏改变了流动表面的粗糙程度,增加了孔隙表面对H2O分子的吸引力.随表面结构破坏程度的增大,水溶液在近壁区域的密度增大,流速降低;当表面破坏程度达到50%时,水溶液在近壁区域出现了明显的负边界滑移现象.     

A theoretical computational model of a plate in hypersonic flow

A theoretical model of an elastic panel in hypersonic flow is derived to be used for design and analysis. The nonlinear von Kármán plate equations are coupled with 1st order Piston Theory and linearized at the nonlinear steady-state deformation due to static pressure differential and thermal loads. Eigenvalue analysis is applied to determine the system’s stability, natural frequencies and mode shapes. Numerically time marching the equations provides transient response prediction which can be used to estimate limit cycle oscillation amplitude, frequency and time to onset. The model’s predictive capability is assessed by comparison to an experiment conducted at a free stream flow of Mach 6. Good agreement is shown between the theoretical and experimental natural frequencies and mode shapes of the fluid–structure system. Stability analysis is performed using linear and nonlinear methods to plot stability, flutter and buckling zones on a free stream static pressure vs temperature differential plane.     

Cascaded electron transition in CuWO_4/CdS/CDs heterostructure accelerating charge separation towards enhanced photocatalytic activity

CuWO_4,as an n-type oxide semiconductor with a bandgap of 2.2 eV,has stimulated enormous interest as a potential broad-spectrum-active photocatalyst for environmental pollution remediations.However,rapid charge recombination greatly hinders its practical applications.Herein,we present a cascaded electron transition pathway in a ternary heterostructure consisting of CdS quantum dots,carbon dots(CDs) and CuWO_4 hollow spheres,which proves to greatly facilitate the photogenerated electron-hole separation,and eventually boosts the degradation efficiency of phenol and congo red by 100% and 46%compared to bare CuWO_4.The enhanced performance of the CuWO_4/CdS/CDs heterostructure mainly originates from the unidirectional electron migration from CdS to CuWO_4 and then to the organics through CDs.This work elucidates the electron transfer kinetics in multi-phase system and provides a new design paradigm for optimizing the properties of CuWO_4 based photocatalysts.     

喷流冷却复合陶瓷薄片激光器的热特性仿真分析及实验研究

为分析喷流冷却复合陶瓷薄片激光器的热特性,设计用于冷却复合陶瓷薄片的喷流冷却系统.利用湍流换热理论和计算流体动力学仿真方法建立喷流冷却复合陶瓷薄片激光器的流固耦合热仿真模型,定义评价其冷却能力和冷却均匀性的定量参数.根据该仿真模型得到喷流冷却系统的最优设计参数,并进行实验验证.使用163孔喷板,流量为0.2kg/s,入口温度为20℃,在1200 W泵浦时获得359 W激光输出功率,并测得复合陶瓷薄片上表面的最高温度为92℃.激光输出功率与复合陶瓷薄片上表面温度均与泵浦功率呈近似正线性关系,且温度的实验值与仿真值相符度较高.     

A solvent-governed surface state strategy for rational synthesis of N and S co-doped carbon dots with multicolour fluorescence

ABSTRACT

Multicolour emissive carbon dots (CDs) are widely investigated by virtue of their merits on fluorescent properties. Method on heteroatom doping assisted with various solvents has been proved efficient in achieving multiple-colour-emissive CDs, especially long-wavelength emission. Herein, a synthesis of multicolour-emissive CDs by controlled surface function is reported. By tuning the thermal-pyrolysis temperature and molar ratio of reactants, optimal emission of the resulted CDs gradually shifts from blue to yellow light with the assistance of different solvents. According to the emissive relationship dependent on excitation, fluorescence lifetimes, and FT-IR of these CDs, the different surface states participated with S and N elements on the surface of carbogenic core govern fluorescent colours of the CDs. In terms of the applications, blue CDs (B-CDs) exhibits high sensitivity for ion detections of Ag⁺ and Fe³⁺, which is further illustrated to have different quenching mechanisms each other because that these ions have the affinity interaction with different surface groups of the CDs. Moreover, blue and yellow CDs solutions are mixed with PVP water solution to fabricate white-light CDs/PVP film, which exhibits stable fluorescence with a CIE coordinate of (0.32, 0.33) and endows these CDs as potentially fluorescent nanomaterial in the solid state lighting field.     

新型非对称二苯并[b,f][1,5]二氮杂环辛四烯的合成

以两种不同取代的2-氨基二苯甲酮为原料,氯苯为溶剂,BF3-Et2O为脱水剂,通过分子间脱水一步环化缩合制备非对称二苯并[b,f][1,5]二氮杂环辛四烯衍生物。运用HPLC监控反应过程,优化合成工艺,得到最佳反应条件为:等物质的量的两种不同取代2-氨基二苯甲酮和BF3-Et2O,在氯苯中回流反应12 h。化合物4a^4c为新化合物,其结构经1H NMR,13C NMR和MS(ESI)表征。     

Dynamical Analysis of a New Chaotic Fractional Discrete-Time System and Its Control

This article proposes a new fractional-order discrete-time chaotic system, without equilibria, included two quadratic nonlinearities terms. The dynamics of this system were experimentally investigated via bifurcation diagrams and largest Lyapunov exponent. Besides, some chaotic tests such as the 0–1 test and approximate entropy (ApEn) were included to detect the performance of our numerical results. Furthermore, a valid control method of stabilization is introduced to regulate the proposed system in such a way as to force all its states to adaptively tend toward the equilibrium point at zero. All theoretical findings in this work have been verified numerically using MATLAB software package.     

Relationship between the radial dynamics and the chemical production of a harmonically driven spherical bubble

The sonochemical activity and the radial dynamics of a harmonically excited spherical bubble are investigated numerically. A detailed model is employed capable to calculate the chemical production inside the bubble placed in water that is saturated with oxygen. Parameter studies are performed with the control parameters of the pressure amplitude, the forcing frequency and the bubble size. Three different definitions of collapse strengths (extracted from the radius vs. time curves) are examined and compared with the chemical output of various species. A mathematical formula is established to estimate the chemical output as a function of the collapse strength; thus, the chemical activity can be predicted without taking into account the chemical kinetics into the bubble model. The calculations are carried out by an in-house code exploiting the high processing power of professional graphics cards (GPUs).The results shown that chemical activity can be approximated qualitatively from the values of relative expansion. This could be helpful in order to optimise chemical output of sonochemical reactors either from measurement data or simulations as well.